Product ID:POWER TRIM & TILT FLUID
MSDS Date:09/22/1985
FSC:9150
NIIN:00N051053
MSDS Number: BVNXS

CITGO PETROLEUM CORP

TULSA, OK 74102
US

Emergency Phone: 918-561-5165

Info Phone: 918-491-6215

Cage: 7X110

CITGO PETROLEUM CORP

3758 TULSA, OK 74102 US

Telephone: 918-495-5933

Cage: 7X110

(ORAL,RAT) 25,000

Fraction By Weight: <0.1%

OSHA PEL N/K

ACGIH TLV: N/K

NONHAZARDOUS INGREDIENTS (MIXTURE)

Fraction By Weight: <5%

OSHA PEL N/K

ACGIH TLV: N/K

MINERAL OIL, PETRO DISTILS, SOLV-DEWAXED HEAVY PARAFFINIC

CAS: 64742-65-0

RTECS: PY8038501

Fraction By Weight: 90-95%

OSHA PEL N/K

ACGIH TLV: N/K

PETROLEUM DISTILLATES SOLVENT (ALT CAS

RTECS: 9999999ZZ

OSHA PEL N/K

ACGIH TLV: N/K

NONHAZARDOUS INGREDIENTS (MIXTURE)

Fraction By Weight: <7%

OSHA PEL N/K

ACGIH TLV: N/K

LD50 LC50 Mixture:SEE INGREDIENTS.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:SLIGHTLY TOX, 1 PT TO 1 QT IS APPROX
LETHAL ORAL DOSE FOR 150 LB HUMAN ADULT. ACUTE:INHAL:LOW RISK. IN
ENCLSD SPACES/WHEN HOT, VAPS MAY REACH CONCS SUFFICIENT TO CAUSE
DROW, DIZZ, HDCH, NAUS/LUNG IRRI T. MISTS ABOVE TLV MAY CAUSE CHEM
PNEUM. SKIN:LOW IRRIT. EYE:MAY BE MILDLY IRRIT. INGEST:GENERALLY
LOW (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:TOX. VERY LG AMTS MAY CAUSE
GENERALIZED DEPRESS, HDCH, DROW, NAUS, VOMIT/DIARR. SM DOSES MAY
PRDCE IRRIT & DIARR. CHRONIC:PRLNG &/OR FREQUENT CONT MAY CAUSE
DRYING, CRACKING (DERM) OR FOLLICU LITIS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:INHAL:REMOVE TO FRESH AIR. RESP SUPPORT IF NEC. SEEK MED AID.
SKIN:WASH W/SOAP & WATER. DO NOT WEAR HEAVILY CONTAM CLTHG BEFORE
LAUNDERING. EYES:FLUSH W/LG VOLS OF WATER FOR AT LST 15 MINS. SEE
MD IF ANY COMPLICATIONS ARISE. INGEST:DO NOT INDUCE VOMIT. SEEK
MED AID. INJECTION:SUBCUTANEOUS INJECTION IS MED EMER. SEEK MED AID
IMMED. NOTES TO MD:IF VISCOSITY IS <100 SUS @ 100F CAREFUL
GASTRIC(SUPDAT)

Flash Point Method:COC
Flash Point:390F,199C
Extinguishing Media:CO*2, DRY CHEMICAL, FOAM OR WATER FOG.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:WATER MAY CAUSE FROTHING.

Spill Release Procedures:REMOVE SOURCES OF HEAT OR IGNITION, PROVIDE
ADEQUATE VENTILATION, CONTAIN LEAK. ABSORB SMALL SPILLS W/SUITABLE
MATERIAL SUCH AS RAGS, STRAW OR SAND. REPORT SPILLS AS REQUIRED TO
APPROPRIATE AUTHORITIE S.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:STORE <120F. DO NOT APPLY HIGH HEAT OR
FLAME TO CNTNR. KEEP SEPARATE FROM STRONG OXIDIZING AGENTS. AVOID
PRLNG CONT W/USED OIL.
Other Precautions:CAUT:EMPTY CNTNRS MAY CNTN PROD RESIDUE WHICH COULD
INCL FLAMM/EXPLO VAPS. CONSULT APPROP FED, STATE & LOC AUTHS BEFORE
REUSING, RECNDTNG, RECLAIMING, RECYCLING/DISP OF EMPTY CNTNRS &/OR
WASTE RESIDUE S OF THIS PRODUCT.

Respiratory Protection:NORMALLY NONE REQUIRED. IF HIGH VAPOR OR MIST
CONCENTRATIONS EXPECTED - USE A NIOSH/MSHA APPROVED RESPIRATOR
APPROVED FOR ORGANIC VAPORS & MISTS.
Ventilation:VENT IS REQD WHEN WORK PLACE EXPOS EXCEED TLV. VERY HIGH
MIST CONCS CAN RSLT IN FIRE & EXPLO HAZARD.
Protective Gloves:OIL IMPERVIOUS GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKER GOGGLES .
Other Protective Equipment:WEAR BODY-COVERING WORK CLOTHES TO AVOID
PROLONGED REPEATED EXPOSURE.
Work Hygienic Practices:WASH SKIN THOROUGHLY W/SOAP & WATER. LAUNDER
SOILED WORK CLOTHES BEFORE REUSE.
Supplemental Safety and Health
FIRST AID PROC:LAVAGE W/TIGHT FITTING/CUFFED TUBE IS TO BE PREF OVER
EMESIS. IF VISCOSITY IF >100 SUS @ 100F, EMESIS MAY BE INDUCED FOR
LG QTYS. ASPIR MAY CAUSE CHEM PNEUM/LIPOID PNEUM. SUBCUTANEOUS I
NJECTION REQS PROMPT SURGICAL DEBRIDEMENT. IF NOT FAMILIAR
W/TECHNIQUE, SEEK SKILLED ADVICE. SUS VISCOSITY @ 100F=180.

Vapor Density:>1
Spec Gravity:0.87 (H*2O=1)
Evaporation Rate & Reference:<1 (BUTYL ACETATE=1)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:RED LIQUID; MILD ODOR.
Percent Volatiles by Volume:NEGLIG

Stability Indicator/Materials to Avoid:YES
STRONG OXIDANTS.
Stability Condition to Avoid:NONE.
Hazardous Decomposition Products:(THERMAL): CO, CO*2.

Waste Disposal Methods:IT IS RESPONSIBILITY OF USER TO DETERMINE IF
MATL IS HAZ WASTE AT TIME OF DISPOSAL. CHECK BEFORE DISPOSING TO BE
SURE YOU ARE IN COMPLIANCE W/ALL APPLICABLE FEDERAL, STATE & LOCAL
LAWS & REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.